Badger-meter Compound Series Manuel d'utilisateur télécharger pdf (Page 11)

Periodic Inspection

• Visually inspect the meter for missing hardware, loose screws, broken or scratched register lenses or any other signs of

wear or deterioration.

• Verify that the meter is operating at the proper flow rate and pressure. A loss in pressure, coupled with a decrease in flow

rate, may indicate that the screen in the upstream pipeline—or the meter itself—is clogged with foreign material and

needs cleaning.

Cleaning

• Clean all dirt, grease, moisture or other foreign material from the exterior of the meter. After cleaning, rinse thoroughly

with water.

• In the event that system pressure has been reduced and the upstream filter or meter is clogged, the foreign material

must be flushed out. To flush the screen, open the cleanout plug and purge the foreign material with fresh water from

the service line. If cleaning the screen does not restore system pressure, the compound meter also should be flushed by

purging with fresh service water through the cleanout plugs located on the housing.

User Manual

Page 11 September 2013

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Badger-meter Compound Series Manuel d'utilisateur Page 11